Filter
Top Products
SKU 93218 For technical questions, please call 1-800-444-3353. Page 7
24. Allow the saw blade to spin up to full speed before feeding a workpiece into
it. When turning off the Masonry Saw, allow the saw blade to spin down and stop
on its own. Do not press against the saw blade to stop it.
25. To avoid accidental injury, always wear heavy duty work gloves when
changing the Saw Blade.
26. The Saw Blade will become hot while cutting. Allow the Saw Blade to
completely cool before handling.
27. Do not force the workpiece into the Saw Blade when cutting. Apply moderate
pressure, allowing the Saw Blade to cut without being forced.
28. Turn off the Masonry Saw and allow the Saw Blade to completely stop if the
Saw Blade is to be backed out of an uncompleted cut.
29. Never attempt to remove material stuck in the moving parts of the Masonry
Saw while it is plugged in and running.
30. Always lock the Table in position before transporting the Masonry Saw.
31. Make sure the scrap masonry to be cut off has sufficient room to move
sideways. Failure to do so may result in off-cut binding against the Saw Blade.
32. Always unplug the Masonry Saw from its electrical outlet before changing
blades or accessories, or before performing any inspection, maintenance, or
cleaning procedures.
33. WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of
California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are: lead from lead-based paints, crystalline silica
from bricks and cement or other masonry products, arsenic and chromium from
chemically treated lumber. Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code § 25249.5,
et seq.
)
34. WARNING! People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference to, or failure of the pacemaker.
35. WARNING! The warnings and cautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS