Filter
Top Products
SKU 94488 For technical questions, please call 1-800-444-3353 PAGE 15
Replace the Transmission Box Cover (2F), and secure it with the Screws (1F).
(See Figure C.)
SCREW
(1F)
TRANSMISSION BOX COVER
(2F)
HEX BOLT
(11F)
HEX BOLT
(11F)
TENSIONING NUT
(35F)
BOLT
(14F)
V-BELT
(3F)
FIGURE C
To clean the Pre-Filter 1 (2E), Pre-Filter 2 (3E), Filter Housing (4E), Paper Air
Filter (5E), and Secondary Filter (6E): It is recommended to clean the Pre-Filter
1, Pre-Filter 2, Filter Housing, Paper Air Filter, and Secondary Filter every 48 hours
of use. To do so, pull the Filter Cover Lock Lever (13E) backward to allow the Air
Filter Cover (1E) swing open. Remove the Pre-Filter 1, Pre Filter 2, Filter Housing,
and Paper Air Filter in succession. Clean and dry the parts or replace if necessary.
Once cleaned or replaced, install the parts in reverse order of removal and close
the Air Filter Cover. (See Figure D.)
AIR COVER
LOCK LEVER
(13E)
AIR FILTER COVER
(1E)
PRE-FILTER 1
(2E)
PRE-FILTER 2
(3E)
FILTER HOUSING
(4E)
SECONDARY
FILTER
(6E)
PAPER AIR
FILTER
(5E)
FIGURE D
To service the Spark Plug (2B): If the Engine loses power, is difficult to start, or
runs poorly at idling speed, first check the condition of the Spark Plug. To check
the Spark Plug:
Remove the Spark Plug Cover (4D) located at the front of the Rear Handle (7D).
(See Figure E.)
e.
4.
5.
a.
REV 07e