Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 95136
SAFETY SERVICEOPERATION TECHNIQUESSETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Controls and Indicators
POWER
ON
POWER
WORKING
AIR
CURRENT
MIN MAX
SET
CUTTER
OVER-
HEAT
OFF
240 VOLT INVERTER PLASMA CUTTER
with Digital Display
ITEM 95136
GROUND
TORCH
1
2
3
4
5
6
7
Torch
Connector
Ground
Connector
1. Power Switch.
Up is ON, down is OFF.
2. Digital Amp Meter.
Shows actual cutting current,
which will vary during operation.
3. Thermal Overload Indicator Lamp.
This light will come on, and the device will
shut down if the tool becomes overheated.
Stop trying to use the cutter while leaving the
power switch ON to allow the cooling fan to
operate, and the lamp will turn off automatically
when the machine cools down.
Pay attention to Duty Cycle discussed on page 6.
4. Power ON Light.
5. Power Supply Controller.
6. Mode Selector.
Turns the air supply ON prior to cutting.
7. Working Indicator Light.
Will be on during cutting operation.
Preparing Your Work Area
1. You must have a sturdy work table that is
open below the area you are cutting. Molten
slag will be blown through the work metal,
and must be able to fall away freely.
2. Your work table must allow the work metal to be rmly
clamped to prevent it accidentally falling or moving.
3. The oor and surrounding area of your work site
must not be ammable. A clean cement oor is
recommended. The cutting process will eject
molten metal slag onto the oor, and it will scatter
for 8-10 feet or more in any direction. Have an
adequate re extinguisher available if needed.