Filter
Top Products
Chapter 2 Installing the Cisco 1700 Router
2-10
Cisco 1700 Router Hardware Installation Guide
78-5405-03
Verifying Your Installation
You can verify that you have correctly installed the router by checking the
following LEDs:
• PWR (front panel)—On when power is being supplied to the router.
• OK (front panel)—On when the router software is loaded and functional.
Blinking means that the router is performing a power-on self-test (POST).
• WICØ/WIC1 OK (rear panel)—On when a WAN interface card is correctly
installed in the corresponding WAN interface card slot.
• ETH ACT (front panel)—Blinking when there is network traffic on the local
Ethernet LAN.
• WICØACT or WIC1 ACT (front panel)—Varies depending on the WAN
interface card installed. Refer to Table 1-3 in the “Cisco 1700 Router
Overview” chapter.
• LNK (rear panel)—On when the router is correctly connected to the local
Ethernet LAN through the 10/100 ETHERNET port.