Filter
Top Products
24-15
ATM and Layer 3 Switch Router Software Configuration Guide
OL-1911-05
Chapter 24 Configuring ATM Router Module Interfaces
Configuring LECs on ATM Router Module Interfaces (Catalyst 8540 MSR)
LANE Bridging Between ATM and Ethernet
The following example show how to configure LANE bridging between ATM and Ethernet using the
ATM router module. Figure 24-5 shows an example of a network for LANE bridging between ATM and
Ethernet.
Figure 24-5 Example Network for LANE Bridging Between ATM and Ethernet
Router 1 ATM Interface
Router1# configure terminal
Router1(config)# interface atm 2/0
Router1(config-if)# atm pvc 1 0 5 qsaal
Router1(config-if)# atm pvc 2 0 16 ilmi
Router1(config-if)# lane client ethernet happy
Router1(config-if)# bridge-group 1
Router1(config-if)# end
Router1#
Router 1 Bridge Interface
Router1# configure terminal
Router1(config)# interface BVI1
Router1(config-if)# ip address 130.2.3.1 255.255.255.0
Router1(config-if)# exit
Router1(config)# bridge 1 protocol ieee
Router1(config)# bridge 1 route ip
Router1(config)# bridge irb
Router1(config)# end
Router1#
ATM Switch Router ATM Router Module Interface
Switch# configure terminal
Switch(config)# interface atm 2/0/0
Switch(config-if)# lane client ethernet BACKBONE
Switch(config-if)# bridge-group 1
Switch(config-if)# exit
Switch(config)# bridge 1 protocol ieee
Switch(config)# end
Switch#
ATM Switch Router Ethernet Interface
Switch# configure terminal
Switch(config)# interface gigabitethernet9/0/0
Switch(config-if)# bridge-group 1
Switch(config-if)# end
Switch#
Router 1 Router 2
Catalyst 8540 MSR
ATM router module
Interface ATM 2/0/0
ATM 2/0
GE 9/0/0
GE 9/0/0
45222