Contec CS2000-QD Stud Sensor User Manual


 
- 13 -
Specifications
General:
Power Supply.....................................................10-30 VDC, reverse polarity protected
Power Consumption............................................50mA max.
Output.............................................................. NPN / PNP open collector
Output Current...................................................100mA max., reverse polarity & short
circuit protected
Response Time.................................................. 10 microseconds
Output Voltage Drop........................................... 0.5V max. (NPN) @ 10mA
1.5V max. (NPN) @ 100mA
0.5V max. (PNP) @ 10mA
1.5V max. (PNP) @ 100mA
Emission........................................................... IR LED (880 nm)
Indicators..........................................................Yellow LED - Indicates label backing only
Red LED - Indicates output state and errors
Green LED - Indicates label + label backing
CS2000 Connections..........................................8' cable - 4 conductors
CS2000-QD Connections.....................................6" Quick Disconnect M12 4 Pin Male 
Cable/Connector (Turck P/N RS4.4T-2)
Slot Width.........................................................0.093" (2.4mm)
Slot Depth.........................................................3.00" (76.2mm)
Min. Label Gap (matrix) Detection......................... 0.03" (.76mm)
Housing Material................................................Double Hard Anodized Aluminum