Filter
Top Products
ASSEMBUNGSTAND(FIG.A)
1. Unpackallpartsandgroupbytypeandsize.Refer
tothepartslistforcorrectquantities.
2. Attachthestanddoor(3)tothefrontofthestand
base(5)usingthreescrewsM5"12-12(4).
3. Attachthefloorplate(1)tothestand(5)using
tenscrewsM5"12-12(2).SeePARTSLISTAND
SCHEMATICFORSTANDSECTION.
NOTE:Ashelf(notincluded) canbeaddedtothe
standbase(seenextsectionpriortoinstallingthe
floorplate(1)).
4. Tightenhardware.
5. Placethestandona levelsurfaceandadjustthe
rear-leftadjustablefoot,sothestandiscontacting
thefloor.
Fig.A
INSTALUNG A SHELF (NOT iNCLUDED) (FIG. A-2)
NOTE: Attach shelf before assembling the floor plate.
1. Turn the stand upside down.
2. Rest the shelf board against the 4 shelf support fins
located on the side of the cabinet.
3. Drill 4 apporpiately sized holes, two on each side,
through the cabinet into the shelf endgrain.
4. Secure the shelf with four wood screws (not
included).
5. Tighten the four wood screws.
Fig. A-2 1
SHELF CONSTRUCTION (FIG. A-l)
• Use good quality plywood or solid wood
• The shelf must be installed before the floor plate (1)
(Fig. A).
Fig. A-1 p, 22-1/2 in ,_
J
83" / ,I3/4
t
ASSEMBLE TABLE SAW TO STAND (FIG. B)
1. Place the saw (6) on the stand (5).
2. Line up the four holes in saw base and stand (5).
3. Fasten saw to stand using four hex bolts (7).
4. Tighten all four hex bolts (7).
NOTE: DO NOT OVER TIGHTEN. THiS MAY
DAMAGE THE SAW BASE.
I ,WARNINGI
IF THE STAND WILL NOT BE USED, DO NOT
OPERATE THE TABLE SAW ON THE FLOOR. THiS
IS A VERY DANGEROUS POSiTiON.
Fig. B