Filter
Top Products
5,
Align the hobs in the drum support with the hobs in
the drum (M), Place a 5/16" lock washer on a 5/16-
18 x 5/8" hex head screw, then 5/16" fiat washer
onto the hex head screw, insert the hex head screw
thru the hob in drum support and drum, Thread a
5/16" hex nut onto the hex head screw and tighten
securely, See figure 11, Fasten the remaining
drum supports to the drum in the same manner,
Fig. 12
T
4,
Assemble U-Bracket (H) to Drum (J), Place a 5/16"
lock washer then a 5/16" fiat washer onto a 5/16-
18 x 5/8" hex head screw (K) thru the hob in the
U-Bracket and the hob in the drum, thread a 5/16"
hex nut onto the hex head screw, Repeat this
process for the remaining hob and securely tighten
both screws, NOTE: U-Bracket should be mounted
to the right side of opening (L) in the drum as
shown, See figure 10,
Fig. 11
ME
8,
7,
Place one end of 6°inch diameter flexible hose (N)
over blower/motor outlet(R), Slide one 6°inch
diameter hose clamp (S) down 6°inch flexible hose
and tighten hose clamp to blower/motor outlet,
See figure 12,
Place the other 6-inch hose clamp (T) over the
6-inch flexible hose, Attach the 6-inch flexible hose
to the drum inlet (U) and tighten 6-inch hose clamp,
See figure 12,
12