Filter
Top Products
CHANGING MOTOR VOLTAGE 1, DBCONNECT THE DUST COLLECTOR FROM
THE POWER SOURCE.
MAKE CERTAIN THE DUST COLLECTOR mS
DBCONNECTED FROM THE POWER SOURCE.
The motor supplied with your Dust Collector is a duaU
voUtage 120/240-voUt, singb-phase motor, it is shipped
wired for 120-voUtapplication, if you choose 240-voUt to
operate your machine, the following instructions must
be followed,
2,
3,
4,
Remove the switch box cover,
The motor has four leads, Reconnect the motor
leads for chosen voltage, as shown in the wire
diagram, See figure 19,
The START/STOP switch is a double pole switch,
No changes are required for 120/240 volt operation,
if you are unsure of electrical connections or codes,
contact a certified electrician, All local and state codes
must be followed,
Refer to GROUNDING INSTRUCTION section before
proceeding:
5, Replace the plug with the correct plug with ground
for voltage required, The new plug must meet all
local and state electrical codes,
6, Reassemble switch box cover,
ON/OFF SWITCH CmRCUmTBREAKER
1
4
120 VOLT CONNECTION
ON/OFF SWITCH CiRCUiT BREAKER
1
3
4
240 VOLT CONNECTION
EEiE i
Fig. 19
16