Filter
Top Products
KICKBACK
Kickback occurs when the blades stall rapidly and the saw is driven back towards
you. Blade statling _scaused by any action which pinches the blade in the material
being cut.
IMPORTANT: The best guard against kickback is to avoid dangerous practices.
Z_ DANGER: ALWAYS turn OFF power to saw immediately if the blades bind
or the saw stalls,,Kickback could cause you to lose control of the saw. Loss of
control can lead to serious injury,
ALWAYS provide proper support for the workpiece and hold the saw with
both hands
Kickback is caused By:
1. Twisting the blades while making a cut.
2. Making a cut with a dull, gummed up, or
improperly set blades..
3. Not providing proper support for work'piece.
ALWAYS provide propersupport as shown
In Fig,,3,,
4. Forcing a cut.
5. Cutting warped or wet lumber.,
6 Tool misuse or Incorrectoperating procedures°
7. Contacting the workpiece with blades at less
than full speed.
\ Fig, 3
To Lessen the Chance of Kickback
1. ALWAYS approach the workpiece with
the saw at an angle of approximately
30° to the workptece_(see Fig. 4°)
2. ALWAYS make straight cuts.
Thiswill help prevent twisting the
blade inthe cut,
3. ALWAYS use clean, sharp and
properlyset blades°NEVER make
cutswith dull blades,,
4, ALWAYS propedy support the
workplece before beginning a cut.This will help you avoid pinchingthe blades
(see Fig, 3).
5. ALWAYS use steady, even pressure when making a cuL NEVER force the cut,
6. DO NOT cut wet or warped lumber.
7. ALWAYS hold the saw firmly with both hands andkeep your body in a balanced
position. ALWAYS keep your body positioned toeither side of the saw blades, but
notin line with the saw blades._Thlswilt help you resistthe forces of kickback,
should itoccur,,
IMPORTANT: When using your saw, ALWAYS stay alert and exercise control,
DO NOT remove your saw from the workplece, while the blade is moving,
11
I
I
I
5-25-O6