Filter
Top Products
ADDITIONALRULESFORSAFEOPERATION
I_ WARNING: BESUREtoreadan----_u"nderstandal,tns_ctlonsl Fa'lui'eto 't
follow all instructionslisted be{ow may result in electric shock, fireand/or serious I
personal injury............ I
I. Know your power tooloRead operator's manual carefully. Learn the
applications and limitations, as well as the specific potential hazards related
to this tool. Followingthis rule will reduce the risk of electric shock, fire or serious
injury,
2. ALWAYS wear safety glasses or eye shields when using this saw. Everyday
eyeglasses have only impact.resistant lenses; they are NOT safety glasses°
Followingthis rule will reduce the risk ofserious personal injury°
3o ALWAYS protect your lungs.Wear a face mask or dust mask if the operation
is dusty. Followingthis rule will reduce the risk of serious personal injury.
4. ALWAYS protect your hearingoWear hearing protection during extended
periods of operation. Fo!lowingthisrule will reduce the risk ofserious personal
injury,
5, ALWAYS inspect the tool cords periodically and If damaged have them
repaired at your nearest Sears Service Center or other Authorized Service
FacUlty. ALWAYS be aware of the cord location. Following thisrule will reduce
the riskof electric shock or fire.
6. ALWAYS check for damaged parts. Before further use of the tool, a guard or
other part that is damaged should be carefully checked to determine if it will
operate properly and perform its Intended function. Check for mlsallgnment
or binding of moving parts, breakage of parts, and any other condition that
may affect the tool's operation. A guard or other part that is damaged, should
be properly repaired or replaced at a Sears Service Center. Following thisrule
will reduce the risk of electric shock, fire or serious injury.
7. DO NOT abuse the cord. NEVER use the cord to carry the tool or pull the
plug from the outlet. Keep cord away from heat, oil, sharp edges or moving
parts. Replace damaged cords immediately. Damaged cords increase the risk
of electric shock. Following thisrule will reduce the risk of electrlc shock or fire.
8_ ALWAYS make sure that your extension cord is in good condition.When
using an extension cord be sure to use one that is heavy enough to carry the
current that your toot will draw. A wire gauge size (A.W.G,) of at least t6 is
recommended for an extension 100 feet or less in length. Using an extension
cord that is over 100 feet lntength is not recommended. If in doubt, use the
next heavier gauge. Smaller gauge wires, have greater capacity (16 gauge
wire has more capacity than 18 gauge wire). An undersized cordwill cause a
drop in line voltage, resulting in loss of power and overheating.
9. DO NOT use the tool while tired or under the Influence of drugs_ alcohol or
any medication. Followingthis rule willreduce the dsk ofelectric shock, fire or
serious personal injury..
10. SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to
instruct others who may use this tool. if someone borrows this toot, make
sure they have these instructions also.
!
!
I 5-25-06