Filter
Top Products
ATTACHING REPLACEMENT BLADESTOTHE SAW cont, (See Figs. 16 - 19)
7oPlace the pin (included with the wrench) intothe lined up holes_
8. Tighten the lock nut clockwise with the wrench and then remove the pin from the
blades (see Fig/19)_ This will allow the blades to turn freely,
9. Carefully turn blades with your hand to be sure they easily turn in opposite
directions,,
Fig. 16 Fig. 17
Flange
Fig, 18
GENERAL
I _WARNING: To avoid accidents, ALWAYS disconnect the tooi from the
I
I ppwer sour_ BEFORE cleaning or performing any maintenance.
All parts represent an important part ofthe double insulation system and should be
serviced only at a Sears Service Center
Avoid using solventswhen deantng plasticparts_ Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use,
Use clean cloths to remove dirt. carbon dust, etc.
A wAR'i.G:oo.o_o,oo_,,m"e,o,_.o.o,...0o.o,,oo,_o_o,oon_o.o.
pwoducts, penetrating oils, etcoto come incontactwith plastic parts,,They contain
chemicals that can damage, weaken or destroy plastic,
19
I
I
I
I
5-25-06