Filter
Top Products
Rating
,,, ,
No-load Speed
, i ,i ,,,,,,,,,,,,,, , , ,,,,,, .......
Peak HP
, ,,,, ,,,,,, i,u,,,
Input
, J,t,i
Collets/Nuts and Cutter Bi't 's'hank Diameters
............ ,,p, ,, ,,,,,
Fixed Base Diameter
,, ,,,,,.,.,
Sub Base Opening (Diameter for cutter bit use)
..... ,,,,,,,,
Sub Base Thickness
,, ,,,,,,,,,,,,,,,,,,,.,,, , ,,ll ,, ,,,,,,,, . ,, , ,,,
Fixed Base Depth of Cut
9°5 Amps
25,000 RPM'
13/4
,,,,u,,i
120-volts, 60Hz AC
1/4-in.. 1/2-in..
6qnches
, , II""'"lll'" ' ' '' '' '
1 V4-inches
,, ,, , ,.,,.... ,,,,
0.23-inches (6ram)
,,,, ,. ,,,,,
13/4-inches (45mm)
i ,,,,,,,,,,,, ,, ,, ,,,,
NOTE: This tool is shipped completely assembled. To install or remove bits
or add accessories such as sawdust ejection hoods for hook-up to vacs, see
the following instructions.
SELECTING THE CUTTER BIT
This router comes with 1/4-ino and 1/2-in_ collets/nuts that accept 1/4 and 1/2-inch
diameter shanked cutter bits,
z_ WARNING: Do not use router cutter bits that have a cutter bit diameter
larger than 11/4-inches as they will not fit through the sub-base opening, and
will cause damage to the sub-base, the motor, and could cause serious personal
injury to the operator.
i,, ,,,,,,
NOTE: The sub-base installed on this router has an opening of 11h-inches.
To use cutting bits with a larger diameter, use a sub-base with a larger opening,
sold separately at Sears stores or other Craftsman outlets.
Z_ WARNING: ALWAYS turn motor off and unplug router before making any "7
adjustments or installing accessories. Failure to unplug the router could result
J
in accidental starting which can cause serious personal injury.
14