Filter
Top Products
I ]
WARNING: To ensure safety and reliability, all repairs should be performed
by a qualified service technician at a Sears Service Center.
GENERAL
Only the parts shown on the parts list are intended for repair or replacement by the
customer. All other parts represent an important part of the double insulation system
and should be serviced only be a qualified Sears@ service technician,.
A WARNING: For your safety, ALWAYS turn off switch and unplug router
motor from the power source before performing any maintenance or cleaning.
tt has been found that electric tools are subject to accelerated wear and possible
premature failure when they are used to work on fiber glass boats and sports cars,
wallboard, spackling compounds or plaster.. The chips and grindings from these materials
are highly abrasive to electrical toot pads, such as bearings, brushes, commutators, etco
Consequently, it is not recommended that this tool be used for extended work on any
fiberglass material, wallboard, spackling compound or plaster. During any use on these
materials, it is extremely important that the tool is cleaned frequently by blowing with
an air jeL
A WARNING: Always wear safety goggles or safety glasses with side shields
during power tool operations, or when blowing dust. If operation is dusty, also
wear a dust mask.
ROUTINE MAINTENANCE
l Z_ WARNING: DO NOT at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which may result in serious personal injury.
1. When work has been completed, clean the tool to allow smooth functioning of the
tool over time.
2. Use clean damp cloths to wipe the tool.
3. Check the state of all electrical cables°
4o Keep the motor air openings free from oil, grease and sawdust or woodchips, and
store tool in a dry place°
5. Be certain that all moving parts are welt lubricated, particularly after lengthy exposure
to damp and/or dirty conditions°
_ WARNING: For your safety, ALWAYS turn off switch and unplug router
motor from the power source before performing any maintenance or cleaning.
Refer to Collet/Nut Care and Cutter Bits on page 16 for cleaning care.
30