Filter
Top Products
Owner's Manual Model No. 875.199810 Owner's Manual Model No. 875.199810
Discoi_nect the air tool from air supply
before.changir_ tools or atta_menls_ .....
servicing and during non-operation.
DO not wear loose fitting clothing,
scarves, orneck ties in work area. Loose
clothing may become Caught in moving
paris and result in serious personal injury.
Do not wear jewelry when operating
any tool. Jewelry may become caught in
moving partsand result in serious
personal injury
Do not deprasS trigger when connectin9
the air supply hose.
Never trigger the tool when not applied
to a work object.
Attachments must be securely
attached. Loose attachments can cause
sedous injury.
Protect air lines from damage or
pullcture.
Never point an air tool at oneself or any
other parson. Serious injury could occur.
Check air hoses for weak or worn
conditions before each use. Make sum all
connections ate secure.
Release all pressure from the system
before attempting to install, service,
relocate or perform any maintenance.
Keep allnuts, bolts and screws tight
and ensure equipment is in safe working
condition.
SOme materials such as adhesives and
air powered tool Always examine
accessories before mounting for chips,
cracks, or signs of damage.
Never use mounted points or other
accessories that have been dropped or
exposed to water, solvent or extreme
temperature changes. It isa good practice
tooperate the tool inaprotected
enclosure for one minute after mounting
any accessory.
Always use accessories with an RPM
rating that meets or exceeds the tool
RPM taUng.
Never cany a tool by the hose or putl
the hose to move the tool or a
compressor. Keep hoses away from
heat, oil and sharp edges, Replace any
hose that is damaged, weak or worn.
could cause serious injury with
prolonged exposure. Always work in a
clean, day, well ventilated area.
Tools which contain moving elements,
or drive other moving tools, such as
gnnding wheels, sockets, sanc_ng
discs, etc_, can become entangled in
hair, clothing, jewelry and other loose
objects, resulting in severe injury.
Never wear loose t_ffing apparel which
contains loose straps or ties, that could
become tangled m moving parts of the
tool. Remove any Jewelry_ watches, etc.,
which might become caught by the
tool Keep hands away from moving
parts. Tie up or cover long hair.
Inhalation hazard: Abrasive tools, sj.__h
as g#nders, sanders and cut-off tools
generate dust end abrasive materials
which can be harmful to human lungs
and respiratory system. Always wear
MSHA/NIOSH approved, properly rdting
face mask or respirator when using
such tools.
Improperly maintained tools and
accessories can cause serious injurF
Maintain the tool with care. A properly
ma{ntaiBed tool, with sharp cutting
edges, reduces the risk of binding and
is easier to control.
There is a risk of bursting if the tool is
damaged. Check for misalignment or
binding of moving parts, breakage of
parts and any other condition that
affects the fool's operation, ff damaged,
have the tool serviced before using.
Too_ whP..h cut, sheer, ddll, staple,
punch, r__hiseJ,etc. =re capable of
causing serious injury. Keep the
working part of the tool away from
hands and body,
After an air tool has been lubricated, oil
will discharge through the exhaust port
during the first few seconds of
operation. Thus, the exhaust port must
be covered with a towel before applying
air pressure.
Only use sockets designated "FOR USE
WITH IMPA C TWRENCHES. "Hand tool
sockets can break, creating a hazard
from flying pieces. Always check
sockef_ retainers and drives regularly
for wear or damage and replace when
necessary.
ENG-4 ENG-5