Filter
Top Products
10103101 WED 13:46 FAX 864 964 3314 RYOBI CUSTOMER SERVICE [_011/015
INSTALLING BITS
See FTgure7..
• Lock the switch triggerby placingthe directionof
rotation selector in center position.See Figure5.
• Open or close chuck jawsto a pointwhere the
opening isslightlylargerthan the bitsize you
Intend to use. Also, raise the frontofyour drill
slightly to keep the bitfrom faiUngoutof the chuck
Jaws.
• Insertdrillbit straightInto chuckthe full length of
the jaws as shown in Figure 7.
• Tighten the chuckjaws on drillbit.
CHUCKJAWS
CHUCKBODY
DRILL BIT
CHUCKCOLLAR
PJGHT Fig. 7
IN To tighten the chuckJawson drillbit;grasp and
holdthe collar of the chuckwith one hand,while
rotating the chuck body withyour other hand.
Note= Rotate the chuckbody in the directionof
the arrow marked LOCK to tightenchuckjaws,
• Do not use a wrench totightenor loosenthe
chuckjaws.
jaws at an angle then tightenas shownin Figure
8, This could cause drillbittObe thrownfrom ddn.
resulting In possibleserious personalinjuryor
damage to the chuck.
REMOVING BITS
See Fi#ure Z
• Lockthe switchtrigger by placingthe directionof
rotationselector incenter position.See F/gur_ 5.
• Loosenthe chuckjaws fromdrillbit.
II To loosen:graspand holdthe collarof the chuck
withone hand, whilerotatingchuckbody withyour
other hand. Note: Rotate chuck body in the
directionof the arrow marked UNLOCK to loosen
chuck Jaws.
11 Do not use a wrenchto tightenor loosenthe
chuckjaws.
II Remove drillbitfrem chuckjaws.
ADJUSTABLE TORQUE CLUTCH
Your ddll is equippedwith an adjustabletorque oJutoh
fordrivingdifferenttypes of sorewsintodifferent mate-
dais. The proper settingdepends on the type of mate-
dal and the size of screw you are using,
TO ADJUST TORQUE
• Identify the twenty four torque indicator settings
locatedon the front of your drill. See Figure 9.
• Rotateadjusting ringto the desiredsetting,
• 1 - 4 For drivingsmallscrews.
• 5 - 8 Fordrivingscrewsintosoft
material.
• 9 - 12 For driving screws intosoft and hard
materials.
• 13 - 16 For drivingscrews in hardwood.
• 17 - 20 Forddving large screws.
• 21 - 4,_1,¶For heavydrill(rig.
TO DECREASE
TORQUE
_LDJUSTING
RING
TOINCREASE
TORQUE