Craftsman 973.111430 Cordless Drill User Manual


 
10/O3/O1 WED 13:45 FAX 864 964 3314 RYOBI CUSTOMER SERVICE [_008/015
tools. Failure to do so could resultin objects
being thrown intoyour eyes, resultinginpossible
serious injury.
& o
a careless fraction ofa second is sufficientto
inflictsevere injury.
CHARGING BA'I-FERY PACK
The battery pack for this toolhas been shippedIn a
lowcharge conditionto prevent possible problems.
Therefore, you shouldcharge Itovernightpriorto use.
Note: Batteries will not reach fullchargethe firsttime
they ere charged. Allowseveral cycles(drilling
followed by recharging)for themto become fully
charged.
TO CHARGE
Charge battery pack only with the charger and
charging stand provided.
Make sure power supply is normal house
voltage, 120 volts, 80 Hz, AC only.
Connect charger to power supply.
Place battery pack in chargingstand. Align raised
rib on batterypack with groove in chargingstand.
See Figure 1.
Press clownon battery packto be sure contactson
battery pack engage properlywithcontacts in
chargingstand.
When properly cOnnected,the red lighton charging
stand willturnon.
Note: ffcha_:jerdoesnot chargebatterypeck,return
batterypack, chargerand chargingstandto your
nearestSears RepoJrCenterforelectrioalcheck,
After normal usage, a minimumcharge time of 10
hours Isrequired to recharge a completely
dischargedtool.
The battery pack will become slightly warm to the
touch while charging.This isnormal and does not
indicate a problem.
Do not place charger In an ares of eXtreme heat or
cold, Itwillwork best at normal roomtemperature.
When batteries becomefully charged, unplug
charger frompower supply.