Filter
Top Products
Battery Pack for TPS-6X Crestron TPS-6X-BTP
Setup
Removal
NOTE: The TPS-6X Wireless Touchpanel contains ESD (electrostatic
discharge) sensitive devices. To avoid damaging the unit, perform the
following procedure while wearing a grounding strap that is properly
grounded or on a grounded workstation.
NOTE: To prevent damage to the multi-pin connector and wiring, use
care when handling the TPS-6X-BTP.
Perform the following procedure to remove the existing TPS-6X-BTP
from a TPS-6X touchpanel. A #1 Phillips screwdriver and a small slot
head screwdriver are required.
1. Remove power from the touchpanel, use the included T-pin to
slide the battery switch on the rear to the OFF (down) position and
place the touchpanel face down on a clean, padded work surface.
(Refer to illustration below.)
Bottom View Showing Battery Switch and Screw Locations
Screws Screws
UP
4 • Battery Pack for TPS-6X: TPS-6X-BTP Installation Guide – DOC. 6740A