Filter
Top Products
56 Appendix—Manual Configuration of iSCSI
After discovery is complete, a confirmation screen is displayed.
3
Click
Close
to close the screen.
Manual Storage Array Discovery
1
Launch MDSM.
If this is the first storage array to be set up, the
Add New Storage Array
window is displayed.
2
Select
Manual
and click
OK
.
3
Select
Out-of-band management
and enter the host server name(s) or IP
address(es) of the iSCSI storage array controller.
4
Click
Add
.
Out-of-band management is now successfully configured.
After discovery is complete, a confirmation screen is displayed.
5
Click
Close
to close the screen.
Setting Up the Array
1
When discovery is complete, the name of the first storage array found is
displayed under the
Summary
tab in MDSM.
2
The default name for the newly discovered storage array is
Unnamed
. If
another name is displayed, click the down arrow next to that name and
select
Unnamed
in the drop-down list.
3
Click the
Initial Setup Tasks
option to see links to the remaining post-
installation tasks. For more information about each task, see the
Owner’s
Manual
. Perform these tasks in the order shown in Table B-2.
NOTE: Before configuring the storage array, check the status icons on the
Summary tab to ensure that the enclosures in the storage array are in an Optimal
status. For more information on the status icons, see the
Owner’s Manual
at
dell.com/support/manuals.
book.book Page 56 Thursday, July 18, 2013 5:56 PM