Filter
Top Products
Appendix—Manual Configuration of iSCSI 71
where,
–
<Target_Name>
is the target name as displayed in the target list. Use
the iscsicli ListTargets command to display the target list.
–
<Report_To_PNP>
is T, which exposes the LUN to the operating
system as a storage device.
–
<Target_Portal_Address>
is the IP address of the iSCSI port on the
controller being logged in to.
–
<TCP_Port_Number_Of_Target_Portal>
is 3260.
–
<Login_Flags>
is 0x2 to enable multipathing for the target on the
initiator. This value allows more than one session to be logged in to a
target at one time.
–
<Username>
is the initiator name.
–
<Password>
is the target CHAP secret.
–
<Authtype>
is either 0 for no authentication, 1 for Target CHAP, or 2
for Mutual CHAP.
: NOTE:
<Username>
,
<Password>
and
<Authtype>
are optional parameters.
They can be replaced with an asterisk (*) if CHAP is not used.
–
<Mapping_Count>
is 0, indicating that no mappings are specified
and no further parameters are required.
* * * An asterisk (*) represents the default value of a parameter.
For example, your log on command might look like this:
iscsicli PersistentLoginTarget iqn.1984-
05.com.dell:powervault.6001372000ffe3332xx0000046
72edf2 3260 T 192.168.130.101 * * * 0x2 * * * * *
* * * * 0
To view active sessions to the target, run the following command:
iscsicli SessionList
To support storage array controller failover, the host server must be connected
to at least one iSCSI port on each controller. Repeat step 3 for each iSCSI
port on the storage array that you want to establish as a failover target. The
Target_ Portal_Address is different for each port you connect to.
book.book Page 71 Thursday, July 18, 2013 5:56 PM