Filter
Top Products
6
Fig. 9
ASSEMBLING SWITCH
1. MAKE CERTAIN THE BAND SAW IS DISCON-
NECTED FROM THE POWER SOURCE.
2. CAUTION: THE START/STOP SWITCH-TO-
MOTOR CORD (F) FIG. 9, IS TIED TO VERTICAL
MOUNTING POST (G) OPPOSITE THE MOTOR PUL-
LEY. THIS CABLE TIE (H) PREVENTS THE SWITCH-
TO-MOTOR CORD (F), FROM CONTACTING THE BELT
OR MOTOR PULLEY DURING OPERATION. IMPOR-
TANT: DO NOT REMOVE THIS CABLE TIE UNLESS
YOU ARE USING THE ACCESSORY#28-984HEIGHT
ATTACHMENT WITH THE BAND SAW.
3. Remove two outer hex nuts and lock washers (A) Fig.
10, from the two screws extending out from the back of
the switch box (B).
4. Insert two screws (C) Fig. 10, located on back of
switch box, into two holes (D) located in the band saw
arm.
5. Fasten the switch box (B) to the band saw arm using
two hex nuts and lockwashers (A) Fig. 11, which were re-
moved in STEP 3.
6. Remove screw and cable clamp (E) Fig. 12, from
lower arm of band saw.
7. Insert switch cord (F) Fig. 12, into clamp (E) which
was removed in STEP 6, and fasten switch cord (F) to
band saw as shown. IMPORTANT: CHECK AND MAKE
CERTAIN THE START/STOP SWITCH-TO-MOTOR
CORD (F) FIG. 9, IS NOT CONTACTING MOTOR PULLEY
OR BELT. ADJUST CORD (F) FIG. 9, IF NECESSARY,
THEN TIGHTEN CABLE TIE (H).
Fig. 10
Fig. 11
B
A
C
D
A
B
Fig. 12
F
E