Filter
Top Products
Fig. 16
8
EXTENSION CORDS
Use only three-wire extension cords which have three-prong grounding-type plugs and three-pole receptacle which
accept the tool’s plug. Replace damaged or worn cord immediately. DO NOT ATTEMPT TO REPAIR POWER CORD.
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING
THE SAW
1. To start the saw, press the “START” button (A) Fig. 15.
2. To stop the saw, press the “STOP” button (B) Fig. 15.
Fig. 15
A
B
LOCKING SWITCH
IN THE “OFF” POSITION
IMPORTANT: When the band saw is not in use, the
switch should be locked in the “OFF” position using a
padlock (C) Fig. 16, (with
3
/16 diameter shackle) through
the two holes (D) in the switch plate, as shown in Fig. 16.
NOTE: Padlock shown is available as accessory Model
50-325.
D