Filter
Top Products
ASSEMBLING BELT TENSION LEVER
Assemble the belt tension lever (A) Fig. 7, to the
tensioning mechanism by threading the end of lever (B)
into the tapped hole (C) and tighten lock nut.
ASSEMBLING TOP GUARD AND
DUST CHUTE ASSEMBLY
Two dust chutes (A) Fig. 8, are supplied with the top
guard (B) and are equipped with four-inch diameter
openings. These dust chutes (A) are hinged to allow easy
connection to a dust collection system and also provides
for fast belt changing without removing the guard
assembly (B) from the machine.
To assemble the top guard and dust chute assembly (B)
Fig. 8, to the edge sander proceed as follows:
1. Place a 1/2" flatwasher (C) Fig. 9, on studs (D) and (E).
2. Place top guard and dust chute assembly (B) Fig. 9, on
studs (D) and (E). IMPORTANT: Make certain the top
guard and dust chute assembly (B) is not interfering with
the sanding belt. The slots in the top of guard and dust
chute assembly (B) will allow adjustment.
4. After the top guard and dust chute assembly is
assembled correctly, fasten with two 1/2" flatwashers
and wing knobs (F) Fig. 10.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
7
A
C
B
B
A
A
B
D
C
E
C
F