Filter
Top Products
13
Fig. 23
Fig. 22
KK
JJ
LL
Fig. 24
STARTING AND STOPPING LATHE
To reduce the risk of injury, make sure
that the ON/OFF switch is in the "OFF" position before
plugging cord into outlet. Do not touch the plug’s
metal prongs when unplugging or plugging in the
cord.
To turn lathe on, lift switch paddle (JJ) Fig. 22 up to the
"ON" position. To turn lathe off, push switch paddle down
to the "OFF" position
LOCKING SWITCH IN THE "OFF" POSITION
To reduce the risk of injury, in the event
of a power outage (such as a breaker or fuse trip),
always move the switch to the “OFF” position until
the main power is restored.
IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to prevent
unauthorized use, using a padlock (KK) Fig. 23 with a 1/4"
(6.4 mm) diameter shackle.
MOTOR OVERLOAD PROTECTOR
The tool is equipped with a manual reset circuit breaker.
If the tool is overloaded or stalled too long the circuit
breaker will trip causing the tool to shut off.
To restart:
1. Set the ON/OFF switch to "OFF"
2. Allow the motor to cool 3-5 minutes.
3. Press the reset button (LL) Fig. 24.
4. Resume normal operations.