Filter
Top Products
8
8. Reassemble collar (D) Fig. 7, which was removed in
STEP 1, to column. IMPORTANT: Bottom of collar (D)
MUST NOT be pushed all the way down onto top of rais-
ing rack (E). MAKE SURE top of raising rack (E) is under
bottom of collar (D) and that there is enough clearance to
allow rack (E) to rotate around the column. Then tighten set
screw (Q) being careful not to overtighten.
10. Assemble table raising and lowering handle (N) Fig.
10, to shaft on table bracket. Line up flat on shaft with
screw (O) and tighten screw (O).
Fig. 10
Fig. 7
Fig. 8
Fig. 9
9. Assemble table (G) Fig. 8, to table bracket (H) using
bolt (F). Line up hole (S) in table with hole in table bracket
and insert pin (P) Fig. 9.
D
Q
E
G
H
S
F
P
O
N