Filter
Top Products
12
ALIGNING FENCE TO SAW BLADE
AND SETTING ZERO MARK
blade so that when you rotate the blade by hand, it
just clears the fence when fence is locked, as shown
in Fig. 26.
pointer hardware.
NOTE: If the pointer can’t be set to zero, loosen serrated
hat the saw
is cutting a one-inch piece.
4. If workpiece is not the right length, move pointer as
needed and re-check.
5. Move fence body to left side of blade and set the left
pointer in the same manner.
ADJUSTING THE FENCE TIGHTNESS
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
off the guide tube and turn fence around as shown in
Fig. 25.
If fence is too loose - slightly tighten the two adjusting
If fence is too tight
NOTE:
loosened an equal amount.
and recheck to see if the fence crossarm is completely
pushed down. Adjust further if necessary.
NOTE: Proper tightening allows about 1/8" (3.2 mm)
deflection when the far end of the fence is pushed to
one side or the other.
NOTE:
is still parallel with the miter gauge slot.
FIG. 24
RR
FIG. 25
YY
A1
B1
VV
C1
YY
FIG. 26
YY
UU
FIG. 27