Filter
Top Products
8
FIG. 9
T
FIG. 8
FRONT RAIL TO SAW
head hex socket cap screws and 5/16-18 serrated
flange nuts.
2. Screws are inserted throught the two larger
saw table.
3. Then, fasten those screws underneath the saw table
using the serrated flange nuts. Tighten finger tight.
REAR RAIL TO SAW
rear edge of the saw table.
2. Place 3/8" lock washers on the two 3/8-24 x 1-1/4"
3. Place screws through the two holes in the rail and
thread them into the two threaded holes — one shown
FULLY TIGHTEN THESE YET.
FIG. 12
CC
FIG. 10
ATTACHING EXTENSION TABLE
TO THE RIGHT UNISAW WING
Fig. 8.
NOTE: Make sure the flat washers are against the heads
the extension table is level and in the same plane with
the Unisaw right extension wing and tighten the four
FIG. 11
W
X
Y
AA
BB
flat washer
extension
table
saw wing
R
S
Q
R
U
V