Filter
Top Products
6
ASSEMBLY
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
ATTACHING LEGS TO THE EXTENSION TABLE
1. Lay the extension table upside down on the floor or on
a bench.
NOTE: Lay the table on a blanket or piece of cardboard
to protect the table surface.
so the holes in the leg match the holes in the table.
3. Attach the table leg to the table board with four 1/4-20
as shown in Fig. 2, with nuts placed on screw inside
the table/
4. Fully fastened leg is shown in Fig. 3.
5. Repeat for other leg.
ATTACHING FENCE HOLDERS TO LEGS
socket button head cap screws and four 1/4-20 flange
Insert screw from outside of leg through both holes and
attach the flange nut on the side of the leg that will be
under the table board when it is turned right side up.
NOTE: If you are installing the accessory storage drawer
to the table for the 36" fence, the fence holders need
to be installed on the opposite side of the leg from that
shown in Fig. 4. The holder needs to be to the outside,
so when turned right side up it will not be under the table
board.
FIG. 1
FIG. 4
FIG. 3
A
B
C
G