13
FINAL FENCE CALIBRATION
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
The distance the fence is positioned away from the
located in the cursor. To calibrate the cursor to the saw
blade, make a test cut with the fence locked in position.
Measure the width of the cut piece. Adjust the cursor by
line is aligned with the same marking on the scale as
the width of the cut piece matches the measurement
indicated by the witness line.
MAINTENANCE
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
Fig. 31, monthly to prevent wear.
Apply paste wax to the fence sides and the guide tube
sliding surfaces weekly. Meguiar’s Professional Paste
extension table surface should be waxed.
CAMFOOT PLACEMENT
A properly clamped fence assembly is shown in Fig. 29.
FENCE OPERATION
To move the fence along the guide tube, simply lift up the
the desired position on the guide, and push down locking
NOTE: A magnet (E1) Fig. 29, is provided to hold the
handle in the up position (as shown in Fig. 28) when
moving the fence.
FIG. 29
RR
E1
FIG. 30
F1
G1
FIG. 31
D1
H1
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltaportercable.com/biesemeyer for a list of service
centers or call the BIESEMEYER
®
RR
YY
D1
C1
FIG. 28
