Filter
Top Products
10
TABLE EXTENSION WINGS
This machine uses two table extension wings to help stabilize the machine, and to help support long or wide
workpieces. To attach the table extension wings:
Remove the screws on the ends of the extension rods (A) Fig. 8. Attach the table extension wings (A) Fig. 9 to the
extension rods and secure with the screws just removed. To utilize the supports, pull them out to their full length (Fig.
10).
Fig. 8
Fig. 10
DUST BAG
Insert the dust spout (A) Fig. 11 in the exhaust (B) with the ridges in the up position. Secure with the supplied panhead
screw. Depress the dust bag spring clips (C) Fig. 11, and secure the dust bag spring clips (D) between the ridges on
the spout (A).
Fig. 11
B
A
C
WORK CLAMP
Some Delta miter saws come with a work clamp (A) Fig. 12. If your machine has a work clamp, you can position it in
one of two holes (A) Fig 13 in the left or right side of the base. Use this clamp, especially with short workpieces (B) Fig.
12.
Fig. 12
A
B
Fig. 13
A
Keep your hands out of the path of the saw blade. If necessary, clamp the workpiece in place
before making the cut.
D
A
A
A
Fig. 9