Filter
Top Products
1818
1. Remove the screw (A) Fig. 44 and rotate the cover (B) to the rear (Fig. 45).
2. Press in on the arbor lock (C) Fig. 46 to keep the arbor from turning.
3. Use the supplied wrench (D) Fig. 47 to loosen the arbor screw (E). Turn it clockwise.
4. Remove the arbor screw (E), Fig. 47, outside blade flange (G), Fig. 45, and saw blade (F) Fig. 45 from the saw
arbor.
5. Attach a new saw blade.
C
E
D
Fig. 46
Fig. 47
MAINTENANCE
CHANGING THE BLADE
Use only cross-cutting blades.
Do not use carbide-tipped blades with deep gullets. They can deflect and contact the guard.
Use only 10
″″
diameter saw blades that are rated for 5000 RPM or higher and have 5/8
″″
diameter
arbor holes.
Disconnect the machine from the power source.
A
B
B
Fig. 44
Fig. 45
F
G
T
E
E
T
H
Make sure that the teeth of the saw blade are pointing down at the front. (See Fig. 48.)
6. Attach the outside blade flange(G) Fig. 45 and arbor screw (E) Fig. 47. Press in on the arbor lock (C) Fig. 46 to
keep the arbor from turning. Use the wrench (D) Fig. 47 to tighten the arbor screw by turning it counter-clockwise.
7. Rotate the cover back to its original position and replace the screw removed in STEP 1.
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call
the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).