Filter
Top Products
102
Input Setup
Video Default settings are underlined.
Set the source video.
z “BD”, “TV”, “GAME1” or “GAME2” can be set when “HDMI” (vpage101) or “Component”
(vpage102) has been assigned.
Setting items Setting details
Video Select
Video of another input
source is played back
combined with the playing
audio.
SOURCE : Play the picture and sound of the input source.
BD / DVD / TV / SAT/CBL / GAME1 / GAME2 / V.AUX / DOCK : Select
video input source to view. This can be set for individual input sources.
“BD”, “TV”, “GAME1” and “GAME2” can be selected only when a
component video is assigned as an input source.
NOTE
•It is not possible to select HDMI input signals.
•Input sources for which “Delete” is selected at “Source Delete”
(vpage95) cannot be selected.
Video Mode
Make settings for video
processing.
BD
z
DVD
TV
z
SAT/CBL
GAME1
z
GAME2
z
V.AUX
DOCK
Auto : Process video automatically based on the HDMI content
information.
Game : Always process video appropriate for game content.
Movie : Process video normally.
•If “Video Mode” is set to “Auto”, the mode is switched according to the
input contents.
•If a source is played in both MAIN ZONE (audio and video) and ZONE2
(audio only) modes in the same room, audio in MAIN ZONE and ZONE2
modes may sound out of synchronization, but this is not malfunction. In
this case, setting to “Game” mode may improve audio synchronization.
Setting items Setting details
Component
(Component video)
Set this to change the
component video input
connectors assigned to the
input sources.
BD
DVD
TV
SAT/CBL
GAME1
GAME2
V.AUX
DOCK
RCA
None : Do not assign a component video input connector to the selected
input source.
•At time of purchase, the settings of the different input sources are as
shown below.
Input source BD DVD TV SAT/CBL
Default
setting
None None None RCA
Input source GAME1
GAME2 V.AUX
DOCK
Default
setting
None None None None
•An input source to which an component video input connector cannot be
assigned is displayed as “– – –”.
•When a control dock for iPod is connected, signals cannot be assigned to
the component video connectors.
Default
The “Input Assign” settings
are returned to the default
settings.
Yes : Reset to the defaults.
No : Do not reset to the defaults.
If you select “Default” and press ENTER, the
message “Return settings to the default?”
is displayed. Select “Yes” or “No”, and then
press ENTER.
Basic version
Advanced version
Information
Advanced version
BD