Filter
Top Products
71
Playback
1
Press ZONE SELECT to switch the
zone mode to K (ZONE2).
Input source
select buttons
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press ZONE/DEVICE Z to turn on
the ZONE2 power.
The indicator on the display lights.
•Also press input source select button when
in standby mode, the power turns on.
•When ZONE/DEVICE X is pressed, ZONE2
turns off.
•Power in ZONE2 can be turned on or off by
pressing ZONE2 ON/OFF on the main unit.
4
Press the input source select
button.
The audio signal of the selected source
is output to ZONE2.
•To perform an operation with the main unit, press
ZONE2 SELECT
many times.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select J (MAIN ZONE) in
step 1 then press ZONE/DEVICE X.
Adjusting the volume
(for “q ZONE2 playback by speaker output”)
Use M df to adjust the volume.
GAdjustable rangeH
– – –
–80dB – –40dB – 18dB
(When the “Volume Display” (vpage95) setting is “Relative”)
GAdjustable rangeH
0 – 41 – 99
(When the “Volume Display” (vpage95) setting is “Absolute”)
•At time of purchase, “Volume Limit” (vpage 94) is set to
“–10dB (71)”.
•Turn MASTER VOLUME after pressing ZONE2 SELECT on the main
unit to adjust the sound volume.
•For “w ZONE2 playback by audio output”, adjust the volume on the
connected amplifier.
Turning off the sound temporarily
Press N.
The sound is reduced to the level set at “Mute Level” (vpage94)
in the menu.
•To cancel, either adjust the volume or press N again.
•The setting is canceled when the zone’s power is turned off.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD