Filter
Top Products
59
Set up speakers
7
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER.
Subwoofer Measure
Channel Select
[RETURN] Return
MultEQ XT
Preparation
Set the following items
if necessary.
Amp Assign
Channel Select
Audyssey Auto Setup
Auto Setup Start
[RETURN][ENTER] Enter Cancel
8
Use ui to select a channel.
Front
Select for setting the front speakers to be used. In this
case, go to step 9.
•“Front” can be set when “Amp Assign” is set to
“Front B”.
Subwoofer
Select for no subwoofer to be used. In this case, go
to step 10.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 11.
•“Surround Back” can be set when “Amp Assign” is
set to “NORMAL”.
9
Press o p to select a front speaker.
A
Select this to use front speaker A.
B
Select this to use front speaker B.
A+B
Select this to use front speakers A and B simultaneously.
10
Use o p to set whether or not a subwoofer channel
is measured.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
11
Use o p to set whether or not a surround back
channel is measured.
Measure
(2 sp)
Set for measuring two surround back speakers.
Measure
(1 sp)
Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
12
Press RETURN B.
Proceed to page16
STEP1 Preparation
step 6.
NOTE
After performing Audyssey
®
Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey
®
Auto Setup again.
5
Use o p to select the
conguration of the connected
speakers.
NORMAL
Select the “NORMAL” setting to perform
7.1-channel playback using the surround back
speakers.
ZONE2
Select the “ZONE2” setting to assign the unit’s
built-in power amplifier for ZONE2 and output the
audio in stereo.
Bi-AMP
Select the “Bi-AMP” setting to connect the front
speakers via the bi-amp connection.
Front B
Select the “Front B” setting to use the second set
of front speakers for playback.
F.HEIGHT
Select the “F.HEIGHT” setting to use the front
height speaker for playback.
6
Press RETURN B to exit the “Amp Assign” setting.
Basic version
Advanced version
Information
Advanced version