Filter
Top Products
Type11flaringcupwheelbackingflange
Type1flangeset
7"Type1guard
Grindingbackingflange
Clampnut
Wheelwrench
Softmountspindleprotector
N197992
D284932
D284931
54339-00
22191-00
61820-01
445928-01
i_WARNING: Accessories must be rated for at least the speed
recommended on the tool waming label Wheels and other
accessories running over their rated accessory speed may fly apart
and cause injury. Threaded accessories must have a 5/8"-11 hub.
Every unthreaded accessory must have a 7/8" (22.2 mm) arbor
hole. If it does not, it may have been designed for a circular saw.
Use only the accessories shown on pages 11-13 of this manual.
Accessory ratings must always be above tool speed as shown on
tool nameplate.
Mounting Guard
MOUNTING AND REMOVING GUARD (FIG. 6, 7}
_ WARNING: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. Guard modification that results in reduced coverage
of the accessory could result in severe personal injury. The too/
may be used without a guard only when sanding with conventional
sanding discs. A Type 27 guard (intended for use with depressed
center grinding wheels [Type 2 7and Type29], sanding flap discs, wire
wheels and wire cup brushes) is available at extra cost from your local
dealer or authorized service cente_ Grinding and cutting with wheels
other than Type 27 and 29 require different accessory guards not
included with tool A Type 1 guard is provided for use with the Type 1
wheel. Mounting instructions for accessory guards are shown below
and are also included in the accessory package.
Sanding Flap Discs
soft mount
445928-01
Type 27 guard
D284937 7"
D284939 9"
hubbed sanding
flap disc
soft mount
445928-01
Type 27 guard
D284937 7"
D284939 9"
backingflange
54339-00
non-hubbed sanding
flap disc
clamp nut
22191-00
11
NOTE: Wheel size must match guard size; i.e., a new 7" wheel may
not be used with a 9" guard. The bottom surface of wheel must be
inside the bend of the guard lip.