Filter
Top Products
Instruction Manual
HAS60E-IM-HW
June 2007
NGA 2000 CLD
3 - 11OperationEmerson Process Management GmbH & Co.OHG
b. Serial interface Setup
The submenu "Serial interface Setup" is used to set the
parameters for data transfer between the analyzer and
external devices. The choices in this menu depend on
the configuration of the analyzer. The full specification of
the serial interface is described in its own manual.
In the System SIO Module menu (Figure 3-11) select
"Serial interface setup..."
Figure 3-18: Serial Interface Setup Menu
Options:
• Baud rate:
300, 1200, 2400, 4800, 9600, 19200
• Data bits: 7, 8
• Stop bits: 1, 2
• Parity: None, Even, Odd
• Echo mode: Enabled, Disabled
• Handshake: None, Xon, Xoff
• Transmission delay: 0...100.
Type of installed serial interface: RS232, RS485/2w,
RS485/4w, RS485/4w bus, None.
Communication protocol: AK, MODBUS RTU, None (not
applicable to CLD)
NOTE
The "special protocol definitions..." line accesses
a submenu for setting the parameters of the AK
and MODBUS RTU (not available yet) communi-
cation protocols.
Figure 3-19: AK Protocol Definitions Menu
The value can range from 1 to 50.
Line#1
Measure
0.000 ppm
Back...
-- Serial Interface Setup --
Baud rate:
Data bits:
Stop bits:
Parity:
Echo mode:
Handshake:
Transmission delay:
Type of installed serial interface:
Communication protocol:
Special protocol definitions...
19200
8
1
None
Disabled
Xon/Xoff
0
RS232
AK
Pressure limits...
Line#1
Measure More...
0.000 ppm
Back...
-- AK Protocol Deifinitions --
Device address (RS-485 only): 1