Filter
Top Products
NGA 2000 CLD
Instruction Manual
HAS60E-IM-HW
June 2007
P - 2 Preface Emerson Process Management GmbH & Co.OHG
IMPORTANT
SAFETY INSTRUCTIONS
WIRING AND INSTALLATION OF THIS APPARATUS
The following safety instructions apply specifically to all EU member states. They should be strictly adhered to
in order to assure compliance with the Low Voltage Directive. Non-EU states should also comply with the
following unless superseded by local or National Standards.
1. Adequate earth connections should be made to all earthing points, internal and external, where provided.
2. After installation or troubleshooting, all safety covers and safety grounds must be replaced. The integrity
of all earth terminals must be maintained at all times.
3. To ensure safe operation of this equipment, connection to the mains supply should only be made through
a circuit breaker which will disconnect
all circuits carrying conductors during a fault situation. The circuit
breaker may also include a mechanically operated isolating switch. Circuit breakers or switches must
comply with a recognized standard such as IEC947. All wiring must conform with any local standards.
4. Where equipment or covers are marked with the symbol to the right, hazardous voltages
are likely to be present beneath. These covers should only be removed when power is
removed from the equipment — and then by trained service personnel only.
5. Where equipment or covers are marked with the symbol to the right, there is a danger
from hot surfaces beneath. These covers should only be removed by trained service
personnel when power is removed from the equipment. Certain surfaces may remain
hot to the touch.
6. Where equipment or covers are marked with the symbol to the right, refer to the In-
struction Manual for instructions.
7. Further graphical symbols used in this product:
All graphical symbols used in this product are from one or more of the following standards:
EN61010-1, IEC417, and ISO3864.
Explosion Hazard!
Harmful (to Health)!
Elektrostatic discharge (ESD)
Toxic!
UV Source!
Disconnect from Mains!