Filter
Top Products
2
IP2046/IM
Nov 2006
CONTENTS
Page
1. Introduction 3
2. The MSP400RH ultrasonic level transmitter 3
2.1 Type numbering system 3
2.2 Pressure Equipment Directive 4
2.3 Specifications 4
3. Installation 6
3.1 Location of the MSP400RH transmitter 6
3.1.1 General considerations 6
3.1.2 Liquid surface conditions 7
3.1.3 In-tank / well effects 8
3.1.4 Open Channel Flow installations 8
3.2 Mounting the transmitter above the liquid surface 10
3.3 Wiring 11
3.4 Additional components in the 2 wire loop 12
4. Commissioning / Programming 13
4.1 Display & push buttons 13
4.2 Power up 14
4.3 Programming - important notes 14
4.4 Setting up for the chosen application 15
4.5 Diagnostic data 27
4.6 Loop Test 28
4.7 Engineering Set-up menu 29
5. Maintenance 35
Appendices
Appendix A1 Main Menu - Programming 36
Appendix A2 Diagnostic Menu 38
Appendix A3 Commissioning / Loop test menu 39
Appendix A4 Engineering menu 40
Appendix B Default menu listing 41
Appendix C Listing of non-linear profiles in the MSP400 43
Appendix D Hart Communications with the MSP400 44
Footnote :-
In this manual the following terms are used which refer to trademarks from other manufacturers:
HART: is the protocol adopted for the MSP400 SMART Communications.
HART is a registered trademark of the HART Communications Foundation and is a mnemonic For
Highway Addressable Remote Transducer.
The MSP400 transmitter is a measuring instrument
and should be handled with due
care and attention at all times