Filter
Top Products
Using the MiterFast Tool
The MiterFast™ angle transfer tool converts a corner angle
measurement into a miter setting. The miter line in the
center of the tool is always at the midpoint of the two
angle arms, and when lined up with the saw’s laser,
provides the proper miter angle for the measured corner.
Supplemental User’s Manual 15
Measure the Corner
► For measuring an outside corner, extend the extension
arms as shown in the image below.
► For measuring an inside corner, retract the extension
arms as shown in the second image below.
1. Loosen the lock knob on the MiterFast tool.
2. Place the MiterFast tool in (or on) the corner and slide
the lock knob forward to expand the arms.
3. When the arms are lined up with the corner walls,
retighten the lock knob.
4. Place the MiterFast tool on the saw with one of the
arms up against the fence.
5. Turn on the laser for the saw. (Refer to Using the Laser
Guides
on page 11.)
6. Adjust the miter angle of the saw (refer to Setting the
Miter Angle
on page 12) until either of the laser beams
line up with the miter line on the MiterFast tool.
7. Lock the miter setting on the saw.
8. Fold up the MiterFast tool and return it to its storage
position in the base of the saw.