Filter
Top Products
14
Copying ring
- Fasten the copying ring (9.1) with the screws (9.2) to the
platen from below.
When choosing the size of the copying ring make sure that
the cutter used (9.4) fits through the rings opening.
The distance Y between the workpiece and template is
calculated by:
Y = (Ø copying ring - Ø cutter) / 2
The copying ring can be centred exactly with the centring
cone ZF-OF (9.3) (Order No. 486 035)
Copying device
The copier scanning set KT-OF consists of roller holder, two
copying rollers 16 and 20 mm diam. respectively, and a 3
mm diam. copying pin.
- Fit angle arm WA-OF (10.3) into provided slot at baseplate.
- Select a copying roller (10.1) that suits the workpiece, and a
corresponding milling cutter (copying roller and cutter should
be of same size).
- Precision adjustment of copying roller by means of fine
adjustment device (10.2) (when precision copying, cutter
blade will be in line with the edge of the copying roller) .
- Guide your router with the copying roller alongside the
workpiece to be worked or copied.
4.4 Support of the workpieces
Ensure that your workpieces are securely fixed
and cannot move during routing. Otherwise, there is an
increased risk of accident. Use screw clamps or some other
suitable devices to fix your workpiece.
Metalworking (Aluminium)
The following precautions are to be taken when processing
aluminium for safety reasons:
- Pre-connect a residual current circuit-breaker.
- Connect the machine to a suitable dust extractor.
- Clean tool regularly of dust accumulations in the motor
housing.
- Wear protective goggles.
d) Copy cutting
A copying ring or the copying device is used to exactly
reproduce existing workpieces (both available as accessories).
5 Servicing and maintenance
Any maintenance or repair work that requires
opening of the motor or gear housing should only be carried
out by an authorised Customer Service Centre (name supplied
by your dealer)! Maintenance or repair work carried out by
an unauthorised person can lead to the wrong connection of
the power leads or other components, which in turn can lead
to accidents with serious consequences.
To prevent accidents, always remove the plug
from the power supply socket before carrying out any
maintenance or repair work on the machine! Do not use
compressed air to clean the electrical tool! Do not try to clean
parts inside the machine in this way, as you could let foreign
objects in through the openings of the machine housing.
Certain cleaning agents and solvents are harmful
to plastic parts. Some of these are: gasoline, carbonyl chloride,
cleaning solutions containing chlorine, ammonia and
household cleaners containing ammonia. To assure the
circulation of air, the cool air vents in the motor housing must
always be kept clear and clean.
This unit is fitted with special, automatically disconnecting
carbon brushes. If these become worn, the current is
automatically switched off and the unit shuts down. In this
case, take the unit to an authorised Customer Service Centre
and have the carbon brushes changed.