Filter
Top Products
ASSEMBLY INSTRUCTIONS
All unpainted surfaces are covered with a protective
coating that prevents rust from forming during shipping and
storage. Peel off the plastic cover from the table and remove
this protective coating by rubbing with a rag dipped in
kerosene, mineral spirits or paint thinner. (Dispose of potentially
flammable solvent-soaked rags according to manufacturer’s
safety recommendations.)
A putty knife, held flat to avoid scratching the surface, may also
be used to scrape off the coating followed by clean-up with
solvent. Avoid rubbing the machine’s painted surfaces, as many
solvent-based products will remove paint.
For optimum performance from your machine, make sure you
clean all metal surfaces of the spindles with a mild solvent or
kerosene.
To prevent rust, apply a light coating of paste wax or regular applications of General International “Top Saver” item
# GC-010 or similar after-market protectants to the table surface.
Be sure to work in a well ventilated area for the
entire clean up process.
Before starting the clean up process make sure the
machine is not plugged into a power source. Failure
to comply may lead injury or cause damage to the
machine.
CLEAN UP
The unit should be installed on a flat, sturdy and stable surface able to support the weight of the machine.
Never install the machine over the edge of a table
or workbench.
Never lift the machine by the table; hold and lift
from the insets on the cabinet.
Make sure that the switch is in “OFF” position and that the power
cord is unplugged & install the red stop switch cover plate.
7