Filter
Top Products
INST
ALL THE SANDING SLEEVES ONTO THEIR CORRESPONDING SPINDLES
Step 1
For 1/4, 1/2, & 5/8 spindles loosen the screw on the
bracket clamp ( ) at the bottom of the spindle.
Step 2
Slide the sanding sleeve onto the spindle completely.
Note: the sleeve should slide under the bracket
clamp as shown.
Re-tighten the screw on the bracket
clamp to secure the sleeve in place.
Step 3
Double check that the sleeve is now on the spindle
securely by pulling on the sleeve to make sure it does
not slide off the spindle.
Step 4
For the 1 1/2” and 2”spindles slide the sleeve onto the
spindle.
Step 5
Using the supplied 12 mm wrench tighten the nut on
the top of the spindle by turning counter clockwise
(reverse thread).
Step 6
Double check that the sleeve is now on the spindle
securely by pulling on the sleeve to make sure it does
not slide off the rubber drum. If the sleeve slides on
the drum, continue tightening the nut (step 5) in 1/2
turn increments as needed.
8
TIGHTEN
LOOSEN