Genesis I.C.E. GBDS450 Cordless Sander User Manual


  Open as PDF
of 44
 
11
English
Mounting Belt/Disc Sander
If during operationof the Belt/Disc Sander, thereis any
tendencyforthesandertoslideor"walk"ortotipover,
thenthesandermustbesecuredtoaworkbenchorother
supportingsurfaceusingfasteners(notsupplied)through
thetwoholesinthesanderbase.
ADJUSTMENTS
WARNING: Always be sure that the tool
is switched off and unplugged from the power
source before adjusting, adding accessories,
or checking a function on the tool
.
Adjusting the Belt Tracking (FIG 13)
1.Plugthesanderintothepowersource.
2.Turnswitch‘ON’andimmediately‘OFF’,notingifthebelt
tendstoslideofftheidlerdrumordrivedrum.Ifitdidnot
tendtoslideoff,itisTRACKINGproperly.
3. If the sanding belt moves toward the disc, turn the
trackingknob(3)clockwise1/4turn.
4.Ifthesandingbeltmovesawayfromthedisc,turnthe
trackingknob(3)counterclockwise1/4turn.
5. Turn switch ‘ON and immediately ‘OFF’ noting belt
movement.Re-adjusttrackingknobifnecessary.
Positioning Belt Bed (FIG 14)
Thebeltbedlockscrew(4)locksthebeltbedinahorizontal
orverticalposition.
To adjust the belt bed position
1.Unplugthesanderfromthepowersource.
2.Loosenthelockscrew(4)usingAllenwrenchprovided.
3.Positionbeltbedandre-tightenthelockscrew(4).
OPERATION
WARNING: Always be sure that the tool
is switched off and unplugged from the power
source before adjusting, adding accessories,
or checking a function on the tool
.
ON/OFF Switch (FIG 15)
1. To turn the sander ON,movetheswitch(1)to
the"ON"position.
2.To turn the sander OFF,movetheswitchtothe
"OFF"position.
3.To lock the switch in the OFF position,remove
thesafetykey(2)fromtheswitch.Storethekeyina
safeplace.
FIG 12
1
2
FIG 13
3
FIG 14
4
FIG 15
1
2
 previous next