Filter
Top Products
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG600 Ver. B Publish:2004.08.27 Page: 5/ 6
V. Operation Instruction
WARNING: Please read all of operation instruction before proceeding.
Enter Program Mode
Enter twice the master code : (Default setting is "12345") → Yellow LED will light up →
you are now in the “Programming Mode”.
Exiting from the Program Mode
Press 「#」 → to exit from the programming mode, or if no activation has happened
for 25 seconds , the system will return to the user mode.
System Setting Access Mode
Enter the Programming Mode, Press 「＊ 0」+ 「??」
A. Proximity Only: For Using Card/Tag Only.
?? = 00, setting complete.
B. Proximity or PIN Code to open the door:
?? = 01, setting complete.
C. Proximity + PIN to open the door: Card followed by PIN code to enter.
?? = 02, the setting is complete.
Note 1: After using the proximity card the yellow LED blinks and input the PIN codes. If
wrong PIN code is input it will automatically return to the “User Mode”.
Note 2: 5 continuous wrong pin codes will automatically deletes the card.
Adding and deleting cards
Enter the Programming Mode, Press the card storage slot code： 000~599
A. Green light comes on: This slot code may register the card
I. Show card to readerÆYellow light blinks Æ input 5 digits PIN codes Æ Green light
offÆ enrolled completed Æ（repeat）
II. Show card to readerÆ (4 audible beep) another card has already been input
(duplicate card).
B. Red light comes on: This slot already has a code registered
I. Press 「＊＊」 (deletion) Æ Green light comes on Æ Show card to reader Æ
﹝same as step “A-1”﹞
II. Enter another slot card position.
Note 1: Regardless of system setting access mode select, you must enter a 5-digit PIN
codes after showing the card to complete the register program, otherwise the card
input will not be successful.
Note 2: The master code are not be used for PIN code.
Relocking timer setting
Enter the Programming Mode, Press 「＊1」+「??」
A. Pulse mode:?? = 01~99 seconds, 05 represents 5 seconds → (An audible beep)
indicates setting successfully→to exit from the programming mode, or program other
operating.
B. Latching mode:?? = 00 → (An audible beep) indicates setting successfully→to exit from
the programming mode, or program other operating.
Note: Enter「00」Sets the relay to latching mode. (Correct code or card entered opens the
relay, and the relay stays open until the correct code or card is entered again).