Filter
Top Products
11
holding the blade securing
nut in an anti-clockwise
direction to loosen the nut.
5. Remove the nut, outer
blade flange and blade.
6. Wipe a drop of oil onto the
inner blade flange and the
outer blade flange where
they contact the blade.
7. Fit the new blade onto the
spindle taking care that
the inner blade flange sits
behind the blade.
CAUTION. Always install the
blade with the arrow printed
on the side of the blade
pointing down. The direction
of blade rotation is also
marked on the blade guard and blade cover.
8. Replace the outer blade flange followed by the blade
nut.
9. Use the blade spanner to securely tighten the blade
bolt. (Tighten in a clockwise direction).
10. Replace the blade cover and secure it with the blade
cover locking knobs.
CAUTION. Before using the saw after replacing the blade,
check that all the safety devices are fitted correctly
including the blade guard and that they are all in good
working order.
Run the saw without loading it to ensure the blade runs
true and there are no extraneous noises.
Filling the water compartment
1. The water compartment
(8) is incorporated into the
main housing
2. The water helps to cool
the cutting disc and also
limits the amount of dust
produced during the cutting
process.
3. Fill the water compartment
with water. The maximum
water level is automatically
controlled by the drainage
hole on top of the plug,
the top of this plug acts
as the water fill line. When
the water level exceeds the
maximum level water will
flow out through the hole.
4. Always fill the water
compartment to the top of the water fill line to ensure
the cutting disc is sufficiently cooled.