Filter
Top Products
14
move the assembly to the left or right until the laser
line is in line with the blade.
5. Tighten the laser light assembly locking knob.
Changing the batteries
1. Remove the laser light
assembly (21) from the
laser light arm (19).
2. Slide off the laser light
battery cover (23).
3. Replace both AAA
batteries, taking care to
insert the new batteries
with the correct polarity.
WARNINGS. Use only correct
batteries, 2 x AAA
DO NOT mix old and new
batteries
DO NOT mix alkaline,
standard (carbon-zinc)
or rechargeable (nickel-
cadmium) batteries.
4. Replace the laser light battery cover.
CAUTION. Remove the laser light batteries when the tool
is to be stored without use for a few days or more. If
left in position, the batteries might leak and damage the
laser light assembly. Damage due to leaking batteries is
not covered under warranty.
Maintenance
WARNING. Always ensure that the tool is switched off
and the plug is removed from the power point before
making and adjustments or maintenance procedures.
When you have finished cutting your tiles, always
disconnect the power, empty the water and fully clean
and dry the machine.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Repairs
Only an authorised service centre should replace the
cordset or effect other repairs. If the cordset is damaged
or worn, have it repaired or replaced by an authorised
service centre.