Filter
Top Products
10
Upper guide pin adjustment
1. To adjust the guide pins loosen the 2 screws that hold the
guide pins in place using the 3mm hex key supplied.
2. Press the guide pins together against the band saw blade.
3. Turn the band saw wheel by hand in a clockwise
direction several times to bring the guide pins into the
correct position. Both guide pins should just touch the
saw blade.
4. Tighten the guide pin
locking screws.
CAUTION: Ensure the blade is
not pinched by rotating the
band saw wheel one or two
times by hand.
Lower blade guide adjustment
WARNING. Always ensure that the saw is switched
off and unplugged from the power supply before making
any adjustments.
1. The lower blade guide adjustments consist of a thrust
bearing that supports the band saw blade from the rear
and two guide pins that provide lateral support, these
need to be readjusted after every band saw blade
change or tracking adjustment.
2. The work table needs to be tilted 45° and the door needs
to be open before the thrust bearing locking screw and
guide pins can be adjusted. This helps give better access
to the adjustment screws.
Thrust bearing adjustment
1. To adjust the thrust bearing
loosen the thrust bearing
locking screw using the 3mm
hex key supplied. It is easier
to access the thrust bearing
screw if the work table is
placed on a 45° angle.
2. Adjust the thrust bearing
position until it is 0.5mm away
from the band saw blade.
When the band saw blade
is turned by hand it should
not make contact with the
thrust bearing.
3. Tighten the thrust bearing
locking screw.
Lower guide pin adjustment
1. With the table set to 90° adjust the guide pins by
loosening the 2 screws that hold the guide pins in place
using the 3mm hex key supplied. The lower housing door
needs to be opened to access the screws.
2. Press the guide pins together against the band saw blade.
3. Turn the band saw wheel by hand in a clockwise
direction several times to bring the guide pins into the
correct position. Both guide pins should just touch the
saw blade.