Filter
Top Products
12
The side support bar
locking screws (34) must
be tightened to secure the
support bars in position
(fig. M).
Turning on and off
1. To turn the saw on depress
and hold the on/off trigger
switch (24) (fig. N).
2. To turn the saw off release
the on/off trigger switch (24).
Turning on the
REDEYE® laser line
generator
The REDEYE® laser line
generator emits 2 intense
narrow beams of pure red
light to guide you as you cut.
It improves operator cutting
vision, enables faster set-up,
increases accuracy and improves safety. To turn on the
laser lines press the laser light on/off switch (2) (fig. O).
To turn off the laser press the laser light on/off switch (2)
one more time.
Setting the table square with the blade
1. Make sure that the electrical plug is removed from the
power point.
2. Push the saw arm (5) down to its lowest position and
engage the release knob (6) to hold the saw arm in the
transport position.
3. Loosen the mitre lock (25)
(fig. P).
4. Rotate the table (21) until
the pointer is positioned
at 0º.
5. Tighten the mitre lock (25).
6. Loosen the bevel lock (16)
and set the saw arm (5)
at 0º bevel (the blade at
90º to the mitre table). Tighten the bevel lock (16)
(fig. Q).
7. Place a set square against
the table (21) and the flat
part of the blade. (fig. R)
Note. Make sure that the
square contacts the flat part
of the saw blade, not the
teeth.
8. Rotate the blade by hand
and check the
blade-to-table alignment
at several points.
9. The edge of the set square
and the saw blade should
be parallel.
10. If the saw blade angles
away from the set
square, adjust as follows.
11. Use a 13mm wrench
or adjustable wrench
to loosen the lock nut
securing the 0° bevel
adjustment screw (35)
(fig. S). Also, loosen the
bevel lock (16).
12. Adjust the 0° bevel
adjustment screw (30)
with the 6mm hex key
M
N
O
P
Q
R
90°
S