Filter
Top Products
18
3. Switch on the laser light on/off switch (2).
4. Clamp the workpiece in position using the laser lines to
align the blade with the pencil mark on the workpiece.
NOTE. To cut to the left-hand side of the blade, align the
left-hand laser line with the pencil mark. To cut to the
right-hand side of the blade, align the right-hand laser line
with the pencil mark.
5. Plug in the machine and start the motor.
6. Press the release latch (31).
7. When the blade is at its maximum speed (approximately
2 seconds), lower the blade through the workpiece.
8. After completing the cut, switch off the laser light on/
off switch (2).
9. After each use, clean the laser light assembly (1) as
described below:
• Switch off the laser light switch (2) and then remove
the plug from the power point.
• With the saw arm (5) in the raised position, use a soft
brush to dust away the sawdust build-up around the
assembly.
NOTE. Wear eye protection whilst brushing the dust away.
Maintenance
WARNING. Always ensure that the tool is switched off and
the plug is removed from the power point before making
and adjustments or maintenance procedures.
Power cord maintenance
If the supply cord needs replacing, the task must be
carried out by the manufacturer, the manufacturer’s agent,
or an authorised service centre in order to avoid a safety
hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the saw. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.