Filter
Top Products
10
4. The work table needs to be
tilted 45° or removed
before the thrust bearing
locking screw and guide
pins can be adjusted.
Thrust bearing adjustment
5. To adjust the thrust
bearing loosen the thrust
bearing locking screw using the Allen key supplied. It is
easier to access the thrust bearing screw if the work
table trunnion is placed on a 45° angle.
6. Adjust the thrust bearing position until it is 0.5mm
away from the band saw blade. When the band saw
blade is turned by hand it
should not make contact
with the thrust bearing.
7. Tighten the thrust bearing
locking screw.
Lower guide pin adjustment
8. With the table trunnion
level adjust the guide pins
by loosening the 2 screws
that hold the guide pins in
place using the Allen key supplied. The lower housing
door needs to be opened to access the screws.
9. Press the guide pins together against the band saw
blade.
Note: The right guide pin is accessed through the slot in
the lower housing.
10. Turn the band saw wheel by hand in a clockwise
direction several times to bring the guide pins into
the correct position. Both guide pins should just
touch the saw blade.
11. Tighten the guide pin locking screws.
12. Attach the work table once all adjustments have been
made.
Caution: Ensure the blade is not pinched by rotating the
band saw wheel one or two times by hand.
Housing doors
WARNING. Always ensure
that the saw is switched off
and unplugged from the
power supply before making
any adjustments.
1. The upper housing door
(4) and lower housing
door (5) protect against
contact with the rotating
parts inside the machine.
2. Both housing doors must
be closed and locked, while the machine is in use.
3. To open the upper housing door (4) rotate the upper
housing locking screw (2) to the left and then open
the door.
4. To open the lower housing door (5) rotate the lower
housing locking screw (3) to the left and then open
the door.
Adjusting the rip fence
WARNING. Always ensure that the saw is switched off
and unplugged from the power supply before making any
adjustments.
The rip fence allows you to make parallel cuts in a sheet
of wood, all at the same width.
1. Adjust the rip fence (13) to the required width and
secure it in position using
the rip fence locking
handle (14).
2. The rip fence can be
positioned on both sides
of the blade
3. Ensure that the fence rests
against the wood along its
entire length to give a
consistent parallel cut.
It may be necessary to rotate the lever anti-clockwise
to be able to slide the rip fence over the table and
then clockwise before locking the lever over, so that the
rip fence is fully tightened in place.